Driver DRV8825 (1 pcs)

Know more about Driver DRV8825 (1 pcs)

PROPERTY DRV8825:

• Dimensions: 2x1,5x1,1
• Weight: 25gr

This product is a carrier board or breakout board for TI's DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (http://www.pololu.com/file/0J590/drv8825.pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil.

Here are some of the driver's key features:

• Simple step and direction control interface
• Can interface directly with 3.3 V and 5 V systems
• Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
• Short-to-ground and shorted-load protection
• 4-layer, 2 oz copper PCB for improved heat dissipation
• Exposed solderable ground pad below the driver IC on the bottom of the PCB
• Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
• Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor's rated voltage to achieve higher step rates
• Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
• 45 V maximum supply voltage
• Built-in regulator (no external logic voltage supply needed)
• Module size, pinout, and interface match those of our A4988 stepper motor driver carriers in most respects

Pins are soldered and heatsink included in the package.