28BYJ-48 Stepper Motor 5V View full size

28BYJ-48 Stepper Motor 5V

Reference: 28byj48

The 28BYJ-48 is a small, cheap, 5 volt geared stepping motors. These stepping motors are apparently widely used to control things like automated blinds, A/C units and are mass produced.

More details

Notify me when available

quantity up quantity down

1,75 €

No reward points for this product.


Motor TypeUnipolar stepper motor
Connection Type5 Wire Connection (to the motor controller)
Voltage5 Volts DC
Frequency100 Hz
Step modeHalf-step mode recommended (8 step control signal sequence)
Step angleHalf-step mode: 8 step control signal sequence (recommended) 5.625 degrees per step / 64 steps per one revolution of the internal motor shaftFull Step mode: 4 step control signal sequence 11.25 degrees per step / 32 steps per one revolution of the internal motor shaft
Gear ratioManufacturer specifies 64:1. Some patient and diligent people on the Arduino forumshave disassembled the gear train of these little motors and determined that the exact gear ratio is in fact 63.68395:1. My observations confirm their findings. These means that in the recommended half-step mode we will have:64 steps per motor rotation x 63.684 gear ratio = 4076 steps per full revolution (approximately).
Wiring to the ULN2003 controllerA (Blue), B (Pink), C (Yellow), D (Orange), E (Red, Mid-Point)
Weight30g

Accessories

30 other products in the same category:

Customers who bought this product also bought: