MKS Gen V1.4 3D Printer Controller Board View full size

MKS Gen V1.4 3D Printer Controller Board

Reference: mksgen14

MKS Gen is a feature rich all-in-one electronics solution for Reprap and other CNC devices.

It features an onboard ATmega2560. Its five motor outputs are powered by Pololu pin compatible stepper drivers.

The board features a developer friendly expansion port supporting giving access the same as Ramps1.4.

MKS Gen allow any power supply from 12V-24V.

More details

Notify me when available

Availability: This product is no longer in stock

42,99 €

By buying this product you can collect up to 4 loyalty points. Your cart will total 4 points that can be converted into a voucher of 0,80 €.


Features:

1, 2560 and ramps1.4 set on a board, to solve complicated Ramps1.4 combination of interfaces, the problem of failure prone.

2, support A4988 DRV8825 driver.

3, the circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.

4, using high-quality MOSFET, and better heat dissipation.

5, using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.

6, can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.

7, the firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.

8, can be directly connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel.

9, reserved for motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit.

10, reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.


Package include:

1 x New MKS Gen V1.4 3D Printer Controller Board 


Wiki: http://reprap.org/wiki/MKS_GEN

30 other products in the same category:

Customers who bought this product also bought: