CO-POLYESTER TEMP+ INNOVATEFIL NATURAL 1,75mm

CO-POLYESTER TEMPERATURE+ is an amorphous co-polyester with high temperature resistance. Thanks to its high glass transition temperature and its amorphous nature, it allows you to make very large pieces without worrying about contractions, important features of this material are: ·

• High thermal resistance, achieving up to 110ºC. 
• Endurance against oils, grease and alcohol. 
• Styrene free. 
• Same chemical resistance as PETG 
• Stiffness similar to PC. 
• Good UV resistance.

Innovatefil® TPU HARDNESS+ is delivered in a vacuum bag with a great barrier against moisture so that the filament cannot absorb humidity. Before bagging, the filament follows the strictest quality controls by dehumidifying the raw material until the moisture content is lower than 0.02%.

Once the product is unpacked we recommend to keep it in a dry and dark environment. If not maintained in a suitable environment the material can absorb up to 0.5% atmospheric moisture, this can create water vapour in the extrusion that can end up in a bad surface finish.

PROTECT FROM MOISTURE
Once printing is finished it is recommendable to clean the nozzle eliminating the excess of material to avoid seals and defects unwanted, if several materials are used it is advisable to have a nozzle for each material to avoid being mixed.

More information in www.innovatefil.com