Kit Electrónica 7 Tipos - LEDs, Resistencias, Diodos | Createc 3D

FEATURES – 7 TYPES ELECTRONIC COMPONENTS KIT (LEDs, Resistors, Diodes, Capacitors...)

1. 3 mm LEDs (5 colors) – Green, Red, Yellow, Blue, White
2. 5 mm LEDs (5 colors)
3. Ceramic capacitors (30 different values)
4. Diodes (8 types) – Including 1N4007, 1N4148, Zener, etc.
5. Transistors (18 types) – NPN and PNP such as BC547, S8050, 2N2222
6. Electrolytic capacitors (12 values)
7. 1/4W resistors (30 different values) – From 10Ω to 1MΩ

💡 WHAT IS THIS KIT FOR?

This kit allows you to learn, experiment, and build your own electronic projects easily. It is the perfect starting point for exploring robotics, sensors, and automation.

• Contents: 7 essential types of electronic components
• Ideal for: Students, makers, teachers, educational robotics, basic and advanced electronics
• Compatibility: Arduino projects, breadboards, development boards, sensors, etc.
• Organization: Sorted by type and value in labeled bags or boxes

⚙️ EXAMPLE PROJECTS YOU CAN BUILD

✅ Project 1: Blinking LED with Arduino

1. Connect a 5 mm LED to a digital pin (e.g. pin 8) using a 220Ω resistor.
2. Upload the following code using Arduino IDE:

   
   void setup() {
     pinMode(8, OUTPUT);
   }
   
   void loop() {
     digitalWrite(8, HIGH);
     delay(500);
     digitalWrite(8, LOW);
     delay(500);
   }
       

✅ Project 2: LED Control with a Button (No Arduino)

1. Connect an LED in series with a 330Ω resistor
2. Add a push button between the positive supply and the base of a BC547 transistor (with a 10kΩ resistor)
3. When pressed, the LED turns on — you have built an electronic switch

✅ Project 3: Capacitor Charging LED Effect

1. Connect an electrolytic capacitor in parallel with an LED (1kΩ resistor in series)
2. When power is applied, the capacitor charges and the LED lights up briefly
3. Perfect for explaining basic timing and delay concepts

👨‍🏫 ARE YOU A TEACHER AND DON’T KNOW WHERE TO START? THIS KIT IS FOR YOU

If you teach technology, robotics, or vocational training and are starting with electronics for the first time, this kit is your best ally. It includes the fundamental components needed to run practical lessons from day one, without requiring advanced prior knowledge.

Each component has been carefully selected to help students understand core concepts such as current flow, LED operation, resistance measurement, and transistor switching. Combined with Arduino boards, this kit enables block-based activities, sensor projects, and group challenges. From lighting an LED to building a transistor-based alarm, this kit gives you everything you need to teach electronics with confidence. And if you need support, Createc 3D is here to help as technical education specialists.

🔎 COMPATIBLE WITH:

✔️ Arduino Uno, Mega, Nano, ESP32 boards

✔️ Raspberry Pi, Micro:bit, STM32

✔️ Breadboards, lab power supplies

✔️ Vocational training, secondary education, makerspaces

💬 FREQUENTLY ASKED QUESTIONS

• Is it suitable for beginners? Yes. It includes all the basic components needed to start learning electronics from scratch.
• Does it include resistors with different values? Yes, 30 different resistor values (e.g. 220Ω, 1kΩ, 10kΩ, etc.).
• Can it be used to repair electronic boards? Yes, it includes commonly used components found in household and industrial electronics.